Slant *        6        Forum
Home Home Home
The Place to Go for Slant Six Info!
Click here to help support the Slant Six Forum!
It is currently Mon Dec 02, 2024 2:45 pm

All times are UTC-08:00




Post new topic  Reply to topic  [ 3 posts ] 
Author Message
 Post subject: Low oil shut down
PostPosted: Wed Feb 14, 2007 10:52 am 
Offline
Board Sponsor
User avatar

Joined: Tue Jun 27, 2006 8:21 am
Posts: 1614
Location: Orlando, FL
Car Model:
With all the recent no oil pressure problems I've read about, I am trying to setup a shut down system. I have a MSD ignition 6AL and a 15# "HOB" switch which grounds on a fall of pressure.
One simple way to wire this is to simply connect the white MSD wire to the HOB switch. One problem with this is that on startup you will have no fire until the oil pressure comes up during cranking. I'd like the car to start with a touch of the key. I will have the mini starter which will shorten the time do to the faster cranking. I also could install a monentary push button under the dash (N Open) for use during cranking. When pressure comes up release the button.
My questions:
How long would the cranking be to bring up pressure? If its less than 1.5 seconds, then a simple white wire to the HOB switch is good for me.
The momentary switch works but it would be nice just to turn the key. Does anybody know of a time delay holding relay that could be wired to the start circuit?
I have heard about some alarm systems causing a misfire code on modern computer cars when the car hits a pothole. I believe the relay is jared to the point that is cut ignition momentarly. My worry is that if I use a relay here that a similar misfire condition could happen.
Your thoughs please.

_________________
67Cuda,FAST EZEFI,340cu,CR=10.25,RollerCam&Rocker (XR268HR,#20-810-9)(#1622-16)(EddyRPM#60779,#7576), (MSD6AL,#6425) A904, GearVendorsOD, 8 1/4,3.55:1, ClassicAir
Image


Top
   
 Post subject:
PostPosted: Wed Feb 14, 2007 11:40 am 
Offline
Board Sponsor & Moderator
User avatar

Joined: Thu Oct 17, 2002 7:27 pm
Posts: 14495
Location: Park Forest, Illinoisy
Car Model: 68 Valiant
I have run my car with the white MSD wire hooked to a stock oil pressure switch. The only time that it really cranks over any amount of time is on first start-up of the day.

It really does not hurt anything to crank it over until it builds pressure anyway.

Grainger or McMaster-Carr will probably both have some kind of timer you could wire in though.

_________________
Official Cookie and Mater Tormentor.


Top
   
 Post subject:
PostPosted: Wed Feb 14, 2007 1:47 pm 
Offline
Supercharged

Joined: Thu May 12, 2005 11:50 pm
Posts: 6291
Location: So California
Car Model: 64 Plymouth Valiant
You could add a NC (normally closed) relay between the white wire and the oil pressure switch. Have the starter wire also trigger this relay.

Thus the circuit will be open when cranking the engine, and you'll be bypassing this safety feature when cranking.

_________________
Ed
64 Valiant 225 / 904 / 42:1 manual steering / 9" drum brakes

8)


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 3 posts ] 

All times are UTC-08:00


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited