Splat ?!!
You didn't dent anything important did you?
Hope you're recovery will be complete!
CJ
| Slant Six Forum https://slantsix.org/forum/ |
|
| How to cc head https://slantsix.org/forum/viewtopic.php?t=21861 |
Page 1 of 1 |
| Author: | flatiron [ Wed Feb 14, 2007 7:47 am ] |
| Post subject: | How to cc head |
Hello been awhile since I posted( fell from the garage roof I'm building to keep my Dart and Duster in 16 feet and splat). But I'm ready to move on and start my first engine build and I'm starting with the head. Could some one explain to me how to cc one. Thanks Flatiron |
|
| Author: | Slanted Opinion [ Wed Feb 14, 2007 10:41 am ] |
| Post subject: | |
Hey flatiron There is a good explanation here: http://www.imperialclub.com/Repair/Engi ... ession.htm This site uses the plexiglass sheet method to get an exact calculation of compression ratio. -Mac |
|
| Author: | ceej [ Wed Feb 14, 2007 11:15 am ] |
| Post subject: | |
Splat ?!! You didn't dent anything important did you? Hope you're recovery will be complete! CJ |
|
| Author: | flatiron [ Thu Feb 15, 2007 6:07 am ] |
| Post subject: | |
Back on my feet and ready to pick up were I left off. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|