| Slant Six Forum https://slantsix.org/forum/ |
|
| head gasket for a 225 c.u. 1965 https://slantsix.org/forum/viewtopic.php?t=21972 |
Page 1 of 1 |
| Author: | DDMike65 [ Thu Feb 22, 2007 4:11 pm ] |
| Post subject: | head gasket for a 225 c.u. 1965 |
.....I have a simple question. Is the coolant passage at the front of the head supposed to be blocked off by the head gasket.? .....I have a factory service manual for the 65 Dodge Dart. It has a picture of the head. The picture has two holes at the rear of the head labled "coolant passages" and a hole at the front of the head also labled "coulant passage". This might make a person think that none of those three holes should be blocked off. .....My motor was rebuilt. It ran so hot the car was not usable. After checking every other possiblity I decided the water passages must be badly rusted up. I took the motor apart, but at that point I noticed that the head gasket blocks off the front coolant passage. .....I would appreciate any info. Thank you. |
|
| Author: | Doc [ Thu Feb 22, 2007 6:02 pm ] |
| Post subject: | |
Yes, the front and the middle "large" coolent holes should be blocked-off by the head gasket. DD |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|