| Slant Six Forum https://slantsix.org/forum/ |
|
| 340 Valve springs https://slantsix.org/forum/viewtopic.php?t=21977 |
Page 1 of 1 |
| Author: | flatiron [ Fri Feb 23, 2007 7:09 am ] |
| Post subject: | 340 Valve springs |
When using 340 valve springs in a slant head do you have to do anything to the spring pockets |
|
| Author: | Romeo Furio [ Fri Feb 23, 2007 7:16 am ] |
| Post subject: | 340 springs |
I never did.Don't know what cam you have, if it is big, check for coil bind and clearance between retainer and valve guide. If it is close to stock,(mine was around .425 lift) had no clearance issues. |
|
| Author: | flatiron [ Fri Feb 23, 2007 7:35 am ] |
| Post subject: | |
The cam I intend on using is MP 4286681 |
|
| Author: | argentina-slantsixer [ Fri Feb 23, 2007 10:12 am ] |
| Post subject: | |
you don't need to machine the head, you DO need new plates wich fit properly inside the 340 springs (MP 210429?? ) the stock slant six pring plates are a tad small. |
|
| Author: | ROADRUNNER7169 [ Fri Feb 23, 2007 10:43 am ] |
| Post subject: | |
part # P4452033 they list for $7.00 ea |
|
| Author: | flatiron [ Fri Feb 23, 2007 1:03 pm ] |
| Post subject: | |
I take it you mean the retainers? |
|
| Author: | argentina-slantsixer [ Fri Feb 23, 2007 2:33 pm ] |
| Post subject: | |
Quote: I take it you mean the retainers?
yes the retainers. We call them plates and we call the valve locks "retainers", my bad, sorry.
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|