Anyone have the right bearing numbers for the front wheels (both inner and outer) on a '74 disc brake A body? I figure if I'm pulling my front brakes off to replace the lug studs, I better do the job right and install new bearings as well.

_________________
'74 Duster w/ HEI ignition, beat to snot suspension, A904, 8.25" 3.55 SG rear, still being tuned up and gets 17 MPG

Know how they always build a better idiot? That's me

Check the new Mopar Action mag, Rick put slotted and drilled rotors on his Beeper and mentioned the part numbers.

_________________
'15 Chrysler 200S V6
'74 Duster 360, factory 4 speed car

Looks like Timken SET2 outer, SET17 inner
BCA/National A2 outer, A17 inner.

_________________
一期一会
Too many people who were born on third base actually believe they've hit a triple.

Went to my local NAPA and they had in stock inner and outer bearings and races for both my 65-72 KH's and 73-76 discs. Might try your NAPA.

Yeah that's what I did. Would've rather waited to have Timken bearings delivered, but I want to get this stuff done as soon this week as I can so I can drive the Duster again. Got Federal Mogul bearings, but I'll have a set of Timkens ready to go when it comes time to replace the rotors completely.

_________________
'74 Duster w/ HEI ignition, beat to snot suspension, A904, 8.25" 3.55 SG rear, still being tuned up and gets 17 MPG

Know how they always build a better idiot? That's me