3/8"X1" or 1-1/4" if you can find them. Coarse thread, of course.
| Slant Six Forum https://slantsix.org/forum/ |
|
| Bolt size for water neck? https://slantsix.org/forum/viewtopic.php?t=24430 |
Page 1 of 1 |
| Author: | Mag00 [ Sat Aug 11, 2007 1:52 pm ] |
| Post subject: | Bolt size for water neck? |
Ok, have a laugh, I was in process of R%R on belts hoses plugs, etc to be ready in plenty of time for a TNT or two before the Redding deal... Knowing that the FLAPS therastats can be an iffy proposition, I removed the one in the vehicle and tested it and was fine ... opened at 3 degrees off off the stamped number... Great! now i checked all the ancillaries and the neck looked a little suspect... pitting around the capyure point ... got a new one only had to wait a day went to install.. ooopppsss! unpainted part , won;t do! took one of the neck bolts to get a good color match... now I can't find either bolt nor the good thermo.. I have a new 'stat, but need to know what size bolts do I need to procure? thank you Doofus in Sac |
|
| Author: | slantzilla [ Sat Aug 11, 2007 2:39 pm ] |
| Post subject: | |
3/8"X1" or 1-1/4" if you can find them. Coarse thread, of course.
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|