Slant Six Forum
https://slantsix.org/forum/

Harmonic balancer bolt.......what size head?
https://slantsix.org/forum/viewtopic.php?t=24648		 Page 1 of 1
Author:  ValiantOne [ Sun Aug 26, 2007 7:45 pm ]
Post subject:  Harmonic balancer bolt.......what size head?
Hey guys I need to get a harmonic balancer bolt for my 66 / with a 170cid. Anyone know what the head size is on that puppy?

I want to limit all the different tools I have to hump in to the boneyard this week :)
Author:  slantzilla [ Sun Aug 26, 2007 7:49 pm ]
Post subject: 
You can buy one at the hardware store. 3/4" fine thread 1-1/4" long.

Head size should be 1-1/8". :shock:
Author:  slantasaurus [ Sun Aug 26, 2007 7:50 pm ]
Post subject: 
As you'll find, Slants usually didn't come with a bolt to hold the ballancer. in place. It is a press fit. One can be added, I'm sure someone else will give the specs on size, thread pitch and length. I don't remember off hand.
Author:  ValiantOne [ Mon Aug 27, 2007 11:23 am ]
Post subject: 
Quote:
As you'll find, Slants usually didn't come with a bolt to hold the ballancer. in place. It is a press fit. One can be added, I'm sure someone else will give the specs on size, thread pitch and length. I don't remember off hand.
Ahhh, Haaaa! That may explain the absence of the bolt on my car :oops:

Thank you,

good thing I hav a 1-1/8 socket too. I guess I'll go ahead and put one on anyhow if it wasn't any big dea.
Author:  james longhurst [ Mon Aug 27, 2007 3:11 pm ]
Post subject: 
Nice looking Valiant there! Owned it long? Like the 'Doba in the background. Nice cars.

-James
Author:  ValiantOne [ Mon Aug 27, 2007 8:43 pm ]
Post subject: 
Quote:
Nice looking Valiant there! Owned it long? Like the 'Doba in the background. Nice cars.

-James
\


Thank you James. Just PMed ya.

Chris
Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/