| Slant Six Forum https://slantsix.org/forum/ |
|
| Oil Sending Unit......... https://slantsix.org/forum/viewtopic.php?t=25394 |
Page 1 of 1 |
| Author: | ValiantOne [ Mon Oct 15, 2007 8:00 pm ] |
| Post subject: | Oil Sending Unit......... |
So the 79 motor is now in the 66 Valiant. Today I went to hook up the wire to the oil sending unit. OOOOoops  I never noticed that the 79 oil pump didn't have a sending unit on it. So what is the name of the special socket I need to get the old one off? And where the heck can I get one? I'm also going to check with NAPA tomorrow morning and see if I can get a new sending unit. If they are available and not too much $, maybe I'll just get a new one. Thanks for any info. Chris E. |
|
| Author: | ceej [ Mon Oct 15, 2007 8:04 pm ] |
| Post subject: | |
They'll probably have the socket at Napa also. CJ |
|
| Author: | Doctor Dodge [ Mon Oct 15, 2007 10:09 pm ] |
| Post subject: | |
Quote: ...So what is the name of the special socket I need to get the old one off?
An oil pressure sending unit socket?   (that's what I call it) DD |
|
| Author: | ValiantOne [ Tue Oct 16, 2007 8:48 am ] |
| Post subject: | |
Outstanding  "Oil Pressure Sending Unit Socket", it is then. Thanks guys, C |
|
| Author: | 79AspenSuperSix [ Tue Oct 16, 2007 11:42 am ] |
| Post subject: | |
I just took the sending unit out of my 79 with a six sided deep well socket. 1 1/16" maybe. |
|
| Author: | CStryker [ Tue Oct 16, 2007 1:34 pm ] |
| Post subject: | |
I was always a fan of crescent wrenches for the oil sending units. |
|
| Author: | Brian [ Wed Oct 17, 2007 12:12 pm ] |
| Post subject: | |
Oil pressure sending unit vise grips work pretty well.
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|