can anybody that has o-ringed their block exsplain the procedure for me,is the block and head grooved or just the block?
| Slant Six Forum https://slantsix.org/forum/ |
|
| o-ring https://slantsix.org/forum/viewtopic.php?t=25552 |
Page 1 of 1 |
| Author: | terrylittlejohn [ Sun Oct 28, 2007 6:23 am ] |
| Post subject: | o-ring |
can anybody that has o-ringed their block exsplain the procedure for me,is the block and head grooved or just the block?
|
|
| Author: | Charrlie_S [ Sun Oct 28, 2007 6:29 am ] |
| Post subject: | |
On my engine, just the block is grooved. I have heard of the block being, o-ringed, and the and the head getting a "reciever" groove. but have never seen this. |
|
| Author: | terrylittlejohn [ Sun Oct 28, 2007 7:55 am ] |
| Post subject: | o-ring |
thanks charlie, i am just trying to get some ideas straight i my head as to my head gasket problem and what is the best fix that i can afford.i have been talking to so many people about this i just need to clear my head and do what i need to do. 
|
|
| Author: | slantzilla [ Sun Oct 28, 2007 9:40 am ] |
| Post subject: | |
Mike's last spray motor has the block and head both done. It is the normal way to do it. 
|
|
| Author: | terrylittlejohn [ Sun Oct 28, 2007 1:55 pm ] |
| Post subject: | o-ring |
what type of gasket is he using? |
|
| Author: | slantzilla [ Sun Oct 28, 2007 2:36 pm ] |
| Post subject: | |
Copper |
|
| Author: | Charrlie_S [ Sun Oct 28, 2007 3:20 pm ] |
| Post subject: | |
Quote: Copper
Yeah, Me too.
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|