| Slant Six Forum https://slantsix.org/forum/ |
|
| engnbldr valves https://slantsix.org/forum/viewtopic.php?t=25962 |
Page 1 of 1 |
| Author: | terrylittlejohn [ Wed Nov 21, 2007 3:46 pm ] |
| Post subject: | engnbldr valves |
just got my valves, had to order them through a good mopar racer who was set up for paypal, only took 3wks with ground usps&can post,the valves look really nice and only $80loonies to here,so i am going to do a fresh head and block for blower motor, after what i put this engine through i am going to make it my new backup,it still starts and runs but after 5 blown head gasket and 3sets of cooked rings its time to make my new tuneup on a fresh motor or thats the plan so far 
|
|
| Author: | 66cudavatch [ Wed Nov 21, 2007 8:14 pm ] |
| Post subject: | |
Just sayin hey from St. John's Also I was thinking about picking up some of these engnbldr valves when I get the cash as well. |
|
| Author: | terrylittlejohn [ Thu Nov 22, 2007 3:06 pm ] |
| Post subject: | valves |
hello, nice to hear a voice close to home ,were are you in town?there nice valves hope they flow as well as the 318 ones that i am using now,you can`t beat the price 
|
|
| Author: | Terencejiminy [ Fri Nov 23, 2007 4:21 am ] |
| Post subject: | Engine Builder Valves |
I just got mine (1.70" X 1.44") UPS Wednesday.  LOOK great so far, but still have to get the head and these beauties to my Windsor (Ont.) engine builder for the instal. Then I have been in touch with the BMW America (Inline engine racing) cylinder head GURU in New Jersey (Jim Furdyn) to take a few liberties with my Slant's head, following their years of Porting Technology. Hope for the best. Terry |
|
| Author: | terrylittlejohn [ Fri Nov 23, 2007 7:59 am ] |
| Post subject: | valves |
must be a good shop if your sending you parts up north,over here were lucky the shop knows what a 3 angle valve job is but they are learning 
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|