Slant Six Forum
https://slantsix.org/forum/

front-end/alignment shop in Vancouver/Portland?
https://slantsix.org/forum/viewtopic.php?t=27012		 Page 1 of 1
Author:  Guest [ Tue Feb 05, 2008 10:47 am ]
Post subject:  front-end/alignment shop in Vancouver/Portland?
I usually go to a place here in Vancouver, WA to get my alignment done, and they are reasonable and do a great job.

but...

I am currently buying a front-end kit from Espo that has McQuay Norris parts. I talked for a while with the owner of the alignment shop, and he was saying the kits you buy online are extremely cheap :roll:
He insisted that the Moog parts are the best on the planet, and refused to install this front end kit! What the heck! This place WAS good, but now it sucks!

So my question is, does anyone reccomend any places that would be willing to install this kit for me, check the ride height, and align the car? In the Portland/Vancouver area...hopefully Vancouver :)

Thanks!
Author:  Guest [ Wed Feb 06, 2008 9:08 am ]
Post subject: 
I guess i'll make this a little easier -- what should I expect to pay to have someone install this for me, and align the car?

I just called a place that will do it, he said with installing the kit and aligning it I should expect to pay around $750. Does this sound reasonable?
Author:  ceej [ Sat Feb 16, 2008 8:29 pm ]
Post subject: 
After all the work I did on my front end today, it's possible. :shock:

Sounds a tad high, but I haven't had a shop do this kind of work for a while. The shop rates have gone up quite a bit.

What's in the kit?

I just built a jig to pop UCA bushings out with my press. Works slick.

CJ
Page 1 of 1 All times are UTC-07:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/