| Slant Six Forum https://slantsix.org/forum/ |
|
| New ball joint/new zerc https://slantsix.org/forum/viewtopic.php?t=27348 |
Page 1 of 1 |
| Author: | bbbbbb9 [ Fri Feb 22, 2008 12:00 pm ] |
| Post subject: | New ball joint/new zerc |
Why is the grease not flowing? Bad zercs? Did I thread them in to far? (I don't think I did. Any suggestions? |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|