| Slant Six Forum https://slantsix.org/forum/ |
|
| Bearing size question for forged crank https://slantsix.org/forum/viewtopic.php?t=27782 |
Page 1 of 1 |
| Author: | gmader [ Tue Mar 11, 2008 8:44 pm ] |
| Post subject: | Bearing size question for forged crank |
Hi all, Based on the markings on the mains and rod bearings below, I am guessing that the forged crank I have was ground .010 prior to me getting it. Is this correct? Rod Bearing markings: FM 2375 RA 010 US DX Main Bearing markings: FM 23776A US 0-010 Thrust Bearing markings: FM 2378SA U-010 GO |
|
| Author: | Doctor Dodge [ Tue Mar 11, 2008 10:38 pm ] |
| Post subject: | |
The marking sure look like the bearings are .010 undersize. What does your micrometer or caliper read? |
|
| Author: | gmader [ Wed Mar 12, 2008 6:34 am ] |
| Post subject: | |
The caliper measurements are my next step. I have a couple of crappy calipers, so I gotta be careful with my measurements. |
|
| Author: | gmader [ Wed Mar 12, 2008 8:38 am ] |
| Post subject: | |
Your instincts were right, Doc. I mic'ed the crank, and it was .010 under. Thanks Greg |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|