| Slant Six Forum https://slantsix.org/forum/ |
|
| header flanges https://slantsix.org/forum/viewtopic.php?t=28469 |
Page 1 of 1 |
| Author: | WoodyB [ Sat Apr 19, 2008 8:03 am ] |
| Post subject: | header flanges |
-------------------------------------------------------------------------------- Hey folks... For any of you that are considering building your own headers, here's a source for the flanges...Mark Sanders in SoCal. You can contact him through his email at mr_shakabra@hotmail.com, you might mention the size of primary tubes (1 1/2, 1 5/8, 1 3/4) you're considering using and that you want 1/2" flange stock if you're looking to keep the same plane/alignment as the intake manifold. Hope this helps. |
|
| Author: | Shaker223 [ Sat Apr 19, 2008 8:46 am ] |
| Post subject: | |
Any idea on cost for the flanges? |
|
| Author: | WoodyB [ Sat Apr 19, 2008 6:56 pm ] |
| Post subject: | header flanges |
I can't say what the cost would be as I had him make 3 sets for me. Probably best if you emailed him and inquired. Mark is quite easy to deal with and very fair... |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|