| Slant Six Forum https://slantsix.org/forum/ |
|
| Which kit do I need ? https://slantsix.org/forum/viewtopic.php?t=28483 |
Page 1 of 1 |
| Author: | 00spy [ Sun Apr 20, 2008 12:49 pm ] |
| Post subject: | Which kit do I need ? |
I have a Holley 1920 and there are to set of numbers above the fuel bowl (3220 and 4656) and a set of numbers on the side (12R-4285B) . Which float will be good to get ( Holley 362 B77). I think it is called the hot idle compensator valve ,does the seal or oring come with the kit.I was looking at it ,and when I took the valve out , the o-ring on the bottom looked like an 8-ring. What do I have took take off from the inside of the carb to dip. I see on the metering body ,there is a pastic piece that is under the economizer plunger? and pushes into the checkball , I am pretty sure that needs to go (if so how hard is it to take off and put back on ). Thanks Dave |
|
| Author: | SlantSixDan [ Sun Apr 20, 2008 1:09 pm ] |
| Post subject: | |
Type #4656 = Holley 1920 for 1971 Dodge/Plymouth with 225 engine, automatic trans, Federal/Canada emissions. Float is a Walker # 100-14. Kit is a Walker # 15480A, and does include new seals for the hot idle compensator valve. Metering block does not get dipped in carb cleaner. Use the plastic straw on a can of spray carburetor cleaner to blast-clean the various accessible passages. |
|
| Author: | 00spy [ Sun Apr 20, 2008 1:20 pm ] |
| Post subject: | |
Thanks Dan That is why it is best to ask if you don't know. As soon as i get my distributor ,I will have everything I need for the HEI conversion. Dave |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|