| Slant Six Forum https://slantsix.org/forum/ |
|
| Placement for frame ball stud bracket? https://slantsix.org/forum/viewtopic.php?t=28796 |
Page 1 of 1 |
| Author: | b5cuda [ Tue May 06, 2008 5:28 pm ] |
| Post subject: | Placement for frame ball stud bracket? |
Getting ready to convert my automatic '69 cuda to 4-speed - can anyone tell me exactly where to place the plate that welds onto the outside of the frame rail? Concerned that I get a nice straight angle on the z-bar. Thanks! Bill Hillsboro, OR |
|
| Author: | slantzilla [ Wed May 07, 2008 9:44 am ] |
| Post subject: | |
On my Duster there were some indentations in the outside of the frame rail right by the fenderwell that were there for locating the tab. |
|
| Author: | DusterIdiot [ Wed May 07, 2008 12:07 pm ] |
| Post subject: | Yep... |
Quote: On my Duster there were some indentations in the outside of the frame rail right by the fenderwell that were there for locating the tab.
On my '67 Valiant there was a hole there already but no plate....-D.Idiot |
|
| Author: | b5cuda [ Wed May 07, 2008 6:27 pm ] |
| Post subject: | |
Mine appears to have the z-bar hole pre-drilled but no markings for the plate. Thanks guys! |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|