| Slant Six Forum https://slantsix.org/forum/ |
|
| Dart driveshaft to ford 9 https://slantsix.org/forum/viewtopic.php?t=29167 |
Page 1 of 1 |
| Author: | cackle [ Mon May 26, 2008 8:20 pm ] |
| Post subject: | Dart driveshaft to ford 9 |
Stupid question so here goes, I am installing a slant out of a 68 dart, using the trans and driveshaft. This is going in a 48 GMC with a ford 9 inch that I installed. Is there a u-joint conversion to go from the dart driveshaft to the ford 9? If not I will have to find a Ford driveshaft and have it chopped. |
|
| Author: | gmader [ Mon May 26, 2008 8:27 pm ] |
| Post subject: | |
Try this http://www.slantsix.org/forum/viewtopic ... ion#138292 |
|
| Author: | cackle [ Mon May 26, 2008 8:34 pm ] |
| Post subject: | |
Thanks, I will try 319 at Napa |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|