| Slant Six Forum https://slantsix.org/forum/ |
|
| Head and intake porting https://slantsix.org/forum/viewtopic.php?t=29266 |
Page 1 of 1 |
| Author: | pinkiedog64 [ Sun Jun 01, 2008 7:12 pm ] |
| Post subject: | Head and intake porting |
Is there a template or guide out there for porting the slant six head? I've done a pretty decent gasket matching job, but I don't know where to go from there. Also, is there anything to be done porting wise for an Offenhauser 4 bbl intake? |
|
| Author: | DusterIdiot [ Sun Jun 01, 2008 7:49 pm ] |
| Post subject: | Nope... |
Quote: Is there a template or guide out there for porting the slant six head?
just make sure to get the 'burrs' out of the ports, shave some off the valve guide area, unless you are running O/S valves and high compression.... you won't need to do too much to the head for improvements on the street.... -D.idiot |
|
| Author: | pinkiedog64 [ Sun Jun 01, 2008 8:27 pm ] |
| Post subject: | |
The head is in the shop right now getting o/s valves and has been milled .100 What else can I do to the head noting those modifications? |
|
| Author: | Slanted Opinion [ Mon Jun 02, 2008 5:14 am ] |
| Post subject: | |
Hey Pinkiedog, How much did they charge you for the whole job (oversized valves, seats, and milling)? -Mac |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|