| Slant Six Forum https://slantsix.org/forum/ |
|
| How big of a hole? https://slantsix.org/forum/viewtopic.php?t=29407 |
Page 1 of 1 |
| Author: | Jopapa [ Mon Jun 09, 2008 1:02 pm ] |
| Post subject: | How big of a hole? |
I finally remembered to look inside the wheel well of my Duster to see if it has the reinforcement plate there for the Z-bar mount, and it doesn't. No big deal, since I'll cut a piece from some of my scrap and weld it in (or rather, have it welded in, heh). My question, though, is how big of a hole does it need to have for the Z-bar mount? There's a hole in the sheet metal that looks to be in the right position, but by eyeballing it, it looks to be just a bit larger than 1/2" diameter. I would've thought this would be too big. Am I right? |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|