Slant Six Forum
https://slantsix.org/forum/

Lug studs
https://slantsix.org/forum/viewtopic.php?t=29766		 Page 1 of 1
Author:  70valiant [ Fri Jun 27, 2008 7:09 pm ]
Post subject:  Lug studs
Can you put 1/2" studs in place of 7/16" on a 7 1/4" rear?
Author:  slantzilla [ Sat Jun 28, 2008 10:03 am ]
Post subject: 
If the knurl is small enough you may be able to retap the holes and put 1/2" screw in studs in. I don't think you can get 1/2" press-ins that will work w/o redrilling the holes larger.

What's wrong with using 7/16th press-ins? :D
Author:  70valiant [ Sat Jun 28, 2008 11:52 am ]
Post subject: 
There is nothing wrong with my 7/16 studs.

The real problem is that the Anston Sprints I bought only came with 17 7/16" lug nuts and about 10 1/2" lug nuts. I am having a heck of a time finding this style lug nuts.
Author:  Charrlie_S [ Sat Jun 28, 2008 3:07 pm ]
Post subject: 
Did you check with summit? I got some mag style nuts for my wheels in 7/16.
Remember, if you are drag racing, most tracks require the stud be long enough to extend into the hex area of the nut by at least the diameter of the stud. Also the nuts must be open ended so the length of the stud can be checked. I had to put long studs in my 7 1/4 rear and get open ended lug nuts.
EDIT:

The studs I got are MOR-46150
One set of nuts are CLL-L5012, other set are SUM-7540102
You can go to Summit's web site put these numbers in search, and get the specs, to see if they are what you need.
Author:  70valiant [ Sat Jun 28, 2008 6:48 pm ]
Post subject: 
I tried summit.
The lug nuts I need have a 1/2" shank that is 7/8" thick and a washer that is 1 3/16" in diameter
Image
Page 1 of 1 All times are UTC-07:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/