| Slant Six Forum https://slantsix.org/forum/ |
|
| Changing motor mounts in car https://slantsix.org/forum/viewtopic.php?t=29832 |
Page 1 of 1 |
| Author: | Pierre [ Wed Jul 02, 2008 1:01 am ] |
| Post subject: | Changing motor mounts in car |
I know there have been posts about dropping pans or oil pumps but... what about mounts? I've dropped pan before in my car (71 duster), but I can't remember how much clearance was left on the mounts. Also, is it safe to jack the engine up by the bellhousing? Trying to see if its possible to do it w/o a hoist. Not sure if the aluminum in the 904 is sturdy enough. Was always iffy about using wood under the pan since pickup is so close. |
|
| Author: | Dart270 [ Wed Jul 02, 2008 4:33 am ] |
| Post subject: | |
Yes, no problem. Just leave one side connected at a time and jack up the BH or even the oilpan with a wide block of wood (I've done both). You may have to pull the metal mount/bracket on the engine on one or both sides to slide it all out. Lou |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|