| Slant Six Forum https://slantsix.org/forum/ |
|
| Pulling a Small Block oil pan On a 72-93 Truck https://slantsix.org/forum/viewtopic.php?t=30020 |
Page 1 of 1 |
| Author: | Greg Ondayko [ Tue Jul 15, 2008 7:24 pm ] |
| Post subject: | Pulling a Small Block oil pan On a 72-93 Truck |
Is it possible to pull a SB oil pan on my 77 D200 (2WD) without Lifting the engine / Loosing the Motor Mounts? It is Developing a nasty Driveway spot That will need taken care of. Thanks, Greg |
|
| Author: | Todd360 [ Wed Jul 16, 2008 1:23 am ] |
| Post subject: | |
If I remember correctly-yes. I had mine off of my 82 D150 ( 360 ci ) a couple of times for various reasons. Good Luck Todd |
|
| Author: | Greg Ondayko [ Wed Jul 16, 2008 3:54 am ] |
| Post subject: | |
Thanks Todd. Greg |
|
| Author: | volaredon [ Wed Jul 16, 2008 11:20 am ] |
| Post subject: | |
Yup. Been there, done that. Last one was actually my old 87 B van; I replaced that pan on my lunch hour! (it was handy being able to have the use of a drive on 4 post hoist, when I worked there!) That one did the old Ford trick, of rusting out just below the mounting flange. There was more similarities on the front end of a B van as compared to a D series pickup than many would realize! Susp. was the same, just different steering linkage. |
|
| Author: | nuttyprof [ Sun Dec 06, 2009 6:39 pm ] |
| Post subject: | oil pan |
I've done it in a 77 d-200 small block |
|
| Author: | volaredon [ Sun Dec 06, 2009 8:38 pm ] |
| Post subject: | |
yup had the pan off my 318 in my current DD 83 D 250 after dropping a pushrod down into the pan. Didnt have to jack up the engine or unbolt anything beyond the starter the trans insp. plate (727), and the pan itself. |
|
| Author: | Reed [ Sun Dec 06, 2009 8:55 pm ] |
| Post subject: | |
I replaced the oil pump on a 360 in a 79 B250 van without even dropping the drag link. It did have dual exhaust though. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|