where can i find one
| Slant Six Forum https://slantsix.org/forum/ |
|
| super six intake https://slantsix.org/forum/viewtopic.php?t=30635 |
Page 1 of 1 |
| Author: | theslantingsix [ Tue Aug 19, 2008 2:53 pm ] |
| Post subject: | super six intake |
I have a question: i got a super six intake, will a demon 500 cfm 2bbl bolt up to it or would i have to modify it? |
|
| Author: | DusterIdiot [ Tue Aug 19, 2008 5:14 pm ] |
| Post subject: | No and yes... |
To make that work, 'properly'... You will need a Mr.Gasket 1937 adaptor, and you will need to do some work to open the top of the intake up a bit since the BBD throttle plates are like a couple of quarters compared to your 'half dollar' plates on the 500 cfm 2 barrel.... If you leave it as is and just run the adaptor, it won't breath right and you'll have fun chasing down little problems due to flow. -D.idiot |
|
| Author: | theslantingsix [ Tue Aug 19, 2008 5:41 pm ] |
| Post subject: | |
so basicly extream porting |
|
| Author: | DusterIdiot [ Tue Aug 19, 2008 7:29 pm ] |
| Post subject: | Yep... |
Quote: so basicly extream porting
once you line the 1937 plate over the manifold hole it will become pretty obvious you got a lot of whittling to do...-D.Idiot |
|
| Author: | theslantingsix [ Wed Aug 20, 2008 7:15 am ] |
| Post subject: | |
where can i find one
|
|
| Author: | Wesola78 [ Wed Aug 20, 2008 8:33 am ] |
| Post subject: | |
O'Reilly Auto Parts. If they don't have one in stock, they can order one for you. |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|