Slant Six Forum
https://slantsix.org/forum/

Super Six carb to intake gasket question
https://slantsix.org/forum/viewtopic.php?t=30791		 Page 1 of 1
Author:  dusterguy225 [ Thu Aug 28, 2008 6:16 pm ]
Post subject:  Super Six carb to intake gasket question
The carb rebuild kit (Walker) I bought only came with a 318 carb to intake gasket, not the super six carb to intake gasket. Will the 318 one work?
Author:  SlantSixDan [ Thu Aug 28, 2008 9:12 pm ]
Post subject: 
Please be specific. Which gasket arrived in your kit? Describe it for us, or post a (reasonably small) picture. How thick is it? Two round holes or one big bathtub-shaped hole? End notches or none? And (exactly) what carb are you using?
Author:  Guest [ Thu Aug 28, 2008 9:16 pm ]
Post subject: 
That's the one with the notches in the side, right?

If so, i've had good luck using them as long as the surfaces are flat, and the carb is properly torqued-down and kept that way. I have not experienced vacuum leaks in the notch areas, however others may have.
Author:  dusterguy225 [ Fri Aug 29, 2008 2:13 pm ]
Post subject: 
I am using a Carter BBD. The 318 one in this pic is the one I have. Its about 1/2" thick, give or take.
Author:  SlantSixDan [ Fri Aug 29, 2008 2:21 pm ]
Post subject: 
You ought to be OK using the notched gasket.
Author:  dusterguy225 [ Fri Aug 29, 2008 2:24 pm ]
Post subject: 
Quote:
You ought to be OK using the notched gasket.
Thanks! :D
Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/