Dog-gone it!
I just torqued my spare head onto the engine.
Is there a different torque spec for the ARP fasteners?
CJ
| Slant Six Forum https://slantsix.org/forum/ |
|
| ARP Head Torque https://slantsix.org/forum/viewtopic.php?t=30958 |
Page 1 of 1 |
| Author: | ceej [ Sun Sep 07, 2008 3:16 pm ] |
| Post subject: | ARP Head Torque |
Dog-gone it! I just torqued my spare head onto the engine. Is there a different torque spec for the ARP fasteners? CJ |
|
| Author: | slantzilla [ Sun Sep 07, 2008 3:23 pm ] |
| Post subject: | |
I run mine at 80 ft/lbs. 
|
|
| Author: | ceej [ Sun Sep 07, 2008 4:33 pm ] |
| Post subject: | |
Gotcha. Thanks Man! CJ |
|
| Author: | Shaker223 [ Sun Sep 07, 2008 5:24 pm ] |
| Post subject: | |
The instructions in my box say 70. That's where I put mine at. |
|
| Author: | ceej [ Sun Sep 07, 2008 7:11 pm ] |
| Post subject: | |
I split the difference. 75#. At least by my old torque wrench. I need to get it in to be checked out. Perhaps I'll drop it at the cal lab for a quick "G-Job" tomorrow! CJ |
|
| Author: | Shaker223 [ Mon Sep 08, 2008 4:31 am ] |
| Post subject: | |
Forgot to mention that's 70 using their moly lube on the threads/ nut face. It was higher using 30wt oil but i don't recall what it is. |
|
| Author: | terrylittlejohn [ Mon Sep 08, 2008 6:07 am ] |
| Post subject: | |
i torqued mine to 85ftlbs with oil, just to help my head gasket problems. |
|
| Author: | Doc [ Mon Sep 08, 2008 9:02 am ] |
| Post subject: | |
I also start with 80 ftlbs on a cast iron SL6, then bump it up to 85 on a warm retorque, after a couple of heat cycles. DD |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|