| Slant Six Forum https://slantsix.org/forum/ |
|
| slant Dowel kit? https://slantsix.org/forum/viewtopic.php?t=3137 |
Page 1 of 1 |
| Author: | DusterIdiot [ Sat Jan 19, 2002 2:39 pm ] |
| Post subject: | slant Dowel kit? |
was going to assemble my topend today and get ready to measure for push rods when I noticed the machinist had pulled the dowels that align the head on the block and he forgot to replace them. anybody know what kits are available (easy to get?) besides going to a Mopar Parts counter and ordering one? thanks... -D.Idiot |
|
| Author: | Dart270 [ Sat Jan 19, 2002 10:27 pm ] |
| Post subject: | Re: slant Dowel kit? |
Quote:
: was going to assemble my topend today and get : ready to measure for push rods when I : noticed the machinist had pulled the dowels : that align the head on the block and he : forgot to replace them. : : anybody know what kits are available (easy to : get?) besides going to a Mopar Parts counter : and ordering one? D-man, I have just used 1/4" stell rod from the hardware store and cut/filed it to fit. Cheap, quick and effective. Lou madsenl@its.caltech.edu |
|
| Author: | Will [ Mon Jan 21, 2002 11:02 pm ] |
| Post subject: | Re: slant Dowel kit? |
Go to autoparts store and buy the ones you need. They cost pennys each!!!!!!!!!!!!!!!!!!!!!!!! Quote:
: was going to assemble my topend today and get : ready to measure for push rods when I : noticed the machinist had pulled the dowels : that align the head on the block and he : forgot to replace them. : : anybody know what kits are available (easy to : get?) besides going to a Mopar Parts counter : and ordering one? : : thanks... : : -D.Idiot slantsix@netzero.net |
|
| Author: | DusterIdiot [ Thu Jan 24, 2002 7:11 pm ] |
| Post subject: | Re: slant Dowel kit? |
Went to autozone they don't have them. Had to special order (minimum 25) from Napa as they don't stock them (same pin works for all mopar G/LA/B blocks and some chevy 4 cylinders... Balkamp #600-1604) uggghhh... At least I'll have spares. -D.Idiot |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|