: Picked up my trans. today from
: KlemRacingTransmissions in Maryland. Boy,I
: really have a case of "Gotta finish the
: Dart" now. My question is, How strong
: is the ball and trunion joint at the front
: of the drive shaft. Will this stand up to
: some hard launching without any worries?
: This is pretty much a budget build-up.Some
: of you might remember my post on ingredients
: suggestions a while back.

: Hey! I bought a small block 727 transmission
: for my 68 340 valiant from klem racing. I
: haven't put it in yet, but looks good. Tell
: us your expierence with Klem as i bought my
: trans from him off of eBay. The drive shaft
: should stand up to it, remember they used
: them behind the first racing Hemi's!

: I agree with Larry, as long as the B&T is in
: good working order, it will be fine. Pull
: back the sheetmetal cover on the front of
: the housing unit and be sure it is packed
: full of long fiber grease.
:
: B&T u-joints last a long time if kept greased,
: ware on the housing or bad needle bearings
: will result in a shaking or vibration under
: load, like a hard launch from a standing
: start.
: DD