| Slant Six Forum https://slantsix.org/forum/ |
|
| Pressure plate bolt size? https://slantsix.org/forum/viewtopic.php?t=32274 |
Page 1 of 1 |
| Author: | redfourjohnd [ Sun Nov 16, 2008 11:50 am ] |
| Post subject: | Pressure plate bolt size? |
Hi Guys, We were finally getting around to putting in the four speed on my 68 charger (thanks again for the flywheel Don!) when we discovered that we didn't have the bolts for the pressure plate, as well as not having any of the right thread in the "misc bolts" coffee can. Can't find it in the factory manual either. Anybody know? Once the transmission is in, I can measure for the driveshaft, get that in, and start driving  Thanks! John D |
|
| Author: | InThePink [ Sun Nov 16, 2008 4:21 pm ] |
| Post subject: | |
Which size clutch/pressure plate are you using? The 10" uses special small head bolts (3/8, I think)- they kind of look like hex head header bolts, but I would imagine they are heat treated. |
|
| Author: | redfourjohnd [ Sun Nov 16, 2008 4:30 pm ] |
| Post subject: | |
It's the 9 1/4 clutch. Just the garden variety, stock replacement from autozone. Thanks! John D |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|