| Slant Six Forum https://slantsix.org/forum/ |
|
| Heater Control Cables https://slantsix.org/forum/viewtopic.php?t=32470 |
Page 1 of 1 |
| Author: | MindforRent [ Thu Nov 27, 2008 7:49 pm ] |
| Post subject: | Heater Control Cables |
Does anyone know a p/n for a the little piece that connects the control cables to the sliders. I can't for the life of me find the one that fell out of sight. |
|
| Author: | steponmebbbboom [ Thu Nov 27, 2008 8:01 pm ] |
| Post subject: | |
what, the push-nut? |
|
| Author: | MindforRent [ Sat Nov 29, 2008 7:21 am ] |
| Post subject: | |
Umm, sure, but what does it look like? |
|
| Author: | steponmebbbboom [ Sat Nov 29, 2008 2:04 pm ] |
| Post subject: | |
is this what you are looking for? http://www.boltproducts.com/palnut%C3%8 ... p-513.html |
|
| Author: | 69a100 [ Sat Nov 29, 2008 3:04 pm ] |
| Post subject: | |
Dude, truck on down to your nearest True Value hardware store and ask/tell the man what your looking for. Unless of course your another one of those purest that has to have the correct part or do without, but who's going to see it to know that it's the wrong part? |
|
| Author: | steponmebbbboom [ Sat Nov 29, 2008 5:29 pm ] |
| Post subject: | |
Quote: Unless of course your another one of those purest that has to have the correct part or do without,
or unless it isnt the push-nut and is something else that a hardware store doesnt carry, in which case truck on down to the junkyard, or hit up an online junkyard like wildcat. or one of us will have it. i don't, sorry.
|
|
| Author: | ESP47 [ Sat Nov 29, 2008 6:15 pm ] |
| Post subject: | |
Are you talking about that funny shaped clip that holds the insulation of the heater cable to the tab? Then theres a screw that goes through it to hold it tighter? |
|
| Author: | MindforRent [ Sat Nov 29, 2008 6:42 pm ] |
| Post subject: | |
its the push nut, I'll head to the hardware store and see what I can find. |
|
| Author: | steponmebbbboom [ Sat Nov 29, 2008 6:45 pm ] |
| Post subject: | |
you may have to go to a specialty fastener store for a push-nut, consumer-level hardware stores rarely get into push-nuts. home depot is a long shot. check the yellow pages under "fasteners" if you get into trouble. |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|