Good day all.

I just installed a electronic distributor and ECU into my 63 Dart GT, these parts are new, being purchased a number of years ago. All went well until I discovered I have no spark at the plugs. I have 12.9V hot into the ballast resistor, 12.9 voltage on the run side. I have verfiied that the coil, wires and plugs are good. What am I missing here?

Dave

_________________
Troops on the battlefield have a far better view of the battle then the generals who lead them

Go through your wiring to make sure all the wires go where they're supposed to go, and make sure your ECM is properly grounded.

_________________
一期一会
Too many people who were born on third base actually believe they've hit a triple.

holy crap dude, welcome back!

_________________
I've been calling it as i see it for my entire life and that's not about to change. Take it or leave it.

I owe the real GT63 my humble appologies , I have been away from these forums for over 3 years (gotta go play in the middle east you know!) and could have sworn that I had the GT63 handle at one time . To avoid future confusion I have up dated my profile.

Dave

what confusion, there is no one else in the memberlist going by the name GT63 but you. i remember you and your posts, the handle is yours.

_________________
I've been calling it as i see it for my entire life and that's not about to change. Take it or leave it.