Quote:
: anyone have info or pics on where on the fuel
: pump to drill and tap for line to boost
: using presure from the preserizes side of a
: turbo? I got a new replacement pump today
: and would like to modify it rather than the
: original one on the car.
: pump to drill and tap for line to boost
: using presure from the preserizes side of a
: turbo? I got a new replacement pump today
: and would like to modify it rather than the
: original one on the car.
Here is a PIC of a high volume pump with a 1/16 NPT fitting installed so a plastic tube & ferrel can be installed. (the same stuff used on mechanical oil pressure and vacuum guages)
If your pump does not have a lot of extra metal around the vent hole, you can also use a hose "bib" fitting like the ones pressed into carbs to accept the small vacuum advance hose. shoot for a tight press fit and use a little epoxy, the hose must be strong enough to hold the boost and be clamped so it won't pop-off under pressure.
DD
