Manifold stud/washer/etc. type info is in this thread (and the threads linked therefrom).
(Quit wearin' yer sunglasses indoors, dude!
)
| Slant Six Forum https://slantsix.org/forum/ |
|
| Replacement Manifold Studs & Valve Seals Need https://slantsix.org/forum/viewtopic.php?t=33876 |
Page 1 of 1 |
| Author: | wjajr [ Fri Feb 20, 2009 10:53 am ] |
| Post subject: | Replacement Manifold Studs & Valve Seals Need |
As some point brass valve guides were installed in my head. The type of oil seal that was used is a 0.6" tall umbrella style that I can't find on line or locally. I also need a few new manifold replacement studs. Any hot tips on part numbers & venders that would have these parts? |
|
| Author: | SlantSixDan [ Fri Feb 20, 2009 11:12 am ] |
| Post subject: | |
0.6" umbrella-type seal is Fel-Pro #SS13955 or Sealed Power #MV1771C (pack of 8 ). Manifold stud/washer/etc. type info is in this thread (and the threads linked therefrom). |
|
| Author: | wjajr [ Fri Feb 20, 2009 1:43 pm ] |
| Post subject: | |
Thanks Dan. I located a bag of studs after getting blown off at NAPA this morning, from a New England Chain; VIP Auto. The Manager made a 15 minute call to VIP's HQ, got the info, and ordered me what I needed. I'm happy. Thanks for the seal part numbers that is a big help. I have ordered a cheep die grinder and several burs for it, and over sized SS valves from Engnbldr. The head is striped & degreased, awaiting for a drink of acid. By next week it should be off to the machine shop for a shave & a cut. |
|
| Author: | wjajr [ Thu Feb 26, 2009 10:17 am ] |
| Post subject: | |
Dan, could you help me out. VIP got me the wrong manifold stud: Dorman 675-092. Do you have a part number for the correct stud? |
|
| Author: | SlantSixDan [ Thu Feb 26, 2009 10:32 am ] |
| Post subject: | |
Manifold stud/washer/etc. type info is in this thread (and the threads linked therefrom). (Quit wearin' yer sunglasses indoors, dude! )
|
|
| Author: | wjajr [ Thu Feb 26, 2009 11:01 am ] |
| Post subject: | |
Thanks Dan, I did not have the shades on. However the guy measuring the sample I presented, and the following phone call was all his gig. Len was hell bent on getting me what I needed then and there... When I returned from the store after making the order, your message with the part number was than read by me. A case of it's in the mail so to speak. Back I go... Thanks again. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|