| Slant Six Forum https://slantsix.org/forum/ |
|
| New Hardened Seats, or not, please advise https://slantsix.org/forum/viewtopic.php?t=34081 |
Page 1 of 1 |
| Author: | wjajr [ Tue Mar 03, 2009 8:06 am ] |
| Post subject: | New Hardened Seats, or not, please advise |
Soon the head will be carted off to the machine shop to cut in new over sized valves (1.70", 1.44") from stock. Do I need to install new hardened seats, or is there enough depth of hardness to just enlarge the stock opening? |
|
| Author: | 66aCUDA [ Tue Mar 03, 2009 8:08 am ] |
| Post subject: | |
I put hardened in the Exhaust only. Frank |
|
| Author: | Red [ Tue Mar 03, 2009 8:52 am ] |
| Post subject: | |
"I put hardened in the Exhaust only" +1 |
|
| Author: | SlantSixDan [ Tue Mar 03, 2009 9:23 am ] |
| Post subject: | |
+2. Hard seats in the exhaust locations. |
|
| Author: | Joshie225 [ Tue Mar 03, 2009 9:28 am ] |
| Post subject: | |
The hardening in the stock exhaust valve seats is often quite shallow. A stock valve job or two and the hardening is usually gone. Hard exhaust seat inserts are the way to go. |
|
| Author: | wjajr [ Tue Mar 03, 2009 4:31 pm ] |
| Post subject: | |
Quote: Hard exhaust seat inserts are the way to go.
Kin'dah figured that, but wanted to check in with the Gurus. Thanks
|
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|