Slant Six Forum https://slantsix.org/forum/ |
|
Valve angles https://slantsix.org/forum/viewtopic.php?t=34234 |
Page 1 of 1 |
Author: | footballhero_7 [ Wed Mar 11, 2009 2:11 pm ] |
Post subject: | Valve angles |
What are the angles that i would grind the valves too on a stock /6? just doina a standard valve job at school |
Author: | bigslant6fan [ Wed Mar 11, 2009 5:15 pm ] |
Post subject: | angles |
The seats are 45,Some people prefer to cut the valves at 45,some at 46 |
Author: | hantayo13 [ Wed Mar 11, 2009 9:17 pm ] |
Post subject: | |
do a triple cut 45 for seat ,70 inside to runner and smooth to runner,10 to face side |
Author: | BMXICAN [ Thu Mar 12, 2009 12:19 pm ] |
Post subject: | |
I read somewhere that intake valves are at 45°, exhaust valves at 43° and all seats at 45°. Would this be correct? |
Author: | 75duster [ Tue Mar 17, 2009 11:45 am ] |
Post subject: | |
that would work. what you dont want is to have the seats and the valves at the same angle. the mismatch helps to keep the seats clean and prevent a chunk of carbon holding a valve open |
Page 1 of 1 | All times are UTC-07:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |