| Slant Six Forum https://slantsix.org/forum/ |
|
| Bearing Removal on Ball and Trunion 4 Speed Tailshaft https://slantsix.org/forum/viewtopic.php?t=34553 |
Page 1 of 1 |
| Author: | Valiant64Vert [ Fri Mar 27, 2009 10:57 pm ] |
| Post subject: | Bearing Removal on Ball and Trunion 4 Speed Tailshaft |
Is the bearing in the tailshaft pressed in? I can't see a snap ring and the manual doesn't say anything about replacement. Does it come out the back if it is pressed out? Thanks from the newbie!  Oh and here's a pic of my new toy, a 64 Valiant vert.  
|
|
| Author: | Doc [ Mon Mar 30, 2009 10:09 am ] |
| Post subject: | |
The rear bearing is not pressed on but it is a tight running fit. DD |
|
| Author: | Valiant64Vert [ Mon Mar 30, 2009 11:16 am ] |
| Post subject: | |
Thanks, I tapped it out yesterday.
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|