| Slant Six Forum https://slantsix.org/forum/ |
|
| Engine building article https://slantsix.org/forum/viewtopic.php?t=34871 |
Page 1 of 1 |
| Author: | oldblue [ Wed Apr 15, 2009 1:13 pm ] |
| Post subject: | Engine building article |
I found this and thought someone might appreciate it http://www.moparmusclemagazine.com/tech ... index.html |
|
| Author: | 1969ronnie [ Wed Apr 15, 2009 6:38 pm ] |
| Post subject: | |
what does 11/410 inch measure? |
|
| Author: | oldblue [ Wed Apr 15, 2009 7:12 pm ] |
| Post subject: | |
0.026829268 divide top# by bottom# to get decimal equivalent. |
|
| Author: | 1969ronnie [ Wed Apr 15, 2009 8:30 pm ] |
| Post subject: | |
i did the math, but you can take a lot more off the head than .026 so i think something is wrong in article. ronnie |
|
| Author: | oldblue [ Thu Apr 16, 2009 4:32 am ] |
| Post subject: | |
Yes you can take more than that off the head,but not for the build they were doing.They had custom rods and pistons.Also a slightly stroked crank. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|