| Slant Six Forum https://slantsix.org/forum/ |
|
| Odd intake https://slantsix.org/forum/viewtopic.php?t=35049 |
Page 1 of 1 |
| Author: | oldblue [ Sat Apr 25, 2009 8:39 pm ] |
| Post subject: | Odd intake |
Found this and thought I would pass it on.The intake port position looks to a GM or ford,but still something different to think about.The ausspeed manifold looks better to me. |
|
| Author: | emsvitil [ Sat Apr 25, 2009 8:42 pm ] |
| Post subject: | |
That 180 degree bend for cyls 3&4 can't be all that good................. |
|
| Author: | MichaelS [ Sun Apr 26, 2009 5:56 am ] |
| Post subject: | |
I had an odd thought for a manifold, What do you all think of taking a stock 1 barrel, aluminum for ease of welding ability, and cutting it parallel to the head, then lengthening the runners by a few inches, 3 or 4, for a long runner 1 barrel manifold. Would this improve torque? HP? This is assuming I could make a clean connection were the runners are lengthened. Just a thought |
|
| Author: | Greg Ondayko [ Sun Apr 26, 2009 6:13 am ] |
| Post subject: | |
Quote: I had an odd thought for a manifold, What do you all think of taking a stock 1 barrel, aluminum for ease of welding ability, and cutting it parallel to the head, then lengthening the runners by a few inches, 3 or 4, for a long runner 1 barrel manifold. Would this improve torque? HP? This is assuming I could make a clean connection were the runners are lengthened.
I think the aussie Intake and the hyperpack have this covered already.Just a thought Greg |
|
| Author: | Red [ Sun Apr 26, 2009 6:38 am ] |
| Post subject: | |
My gut reaction was identical to emsvitil's. |
|
| Author: | MichaelS [ Sun Apr 26, 2009 7:48 am ] |
| Post subject: | |
But I'm thinking cheap, made with junk yard parts, aussie is very nice part, but out of my budget for today. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|