| Slant Six Forum https://slantsix.org/forum/ |
|
| On Carb Part ID https://slantsix.org/forum/viewtopic.php?t=35902 |
Page 1 of 1 |
| Author: | 68barracuda [ Fri Jun 19, 2009 1:20 am ] |
| Post subject: | On Carb Part ID |
Hi Guys - came across the following - Base plates differs on two further identical BBD's - on has LONG idle mixture screws - and the block they are screwing into is much thicker than the the other - mixture screws not interchangeable due to length One has a 2 cast on it on has a 3... what gives? - is ther a guid somwhere with these partnumbers? |
|
| Author: | SlantSixDan [ Fri Jun 19, 2009 7:45 am ] |
| Post subject: | |
A "2" isn't a part number, and neither is a "3". There were variations in the throttle body casting. Some clear, sharp photos, mebbe...? |
|
| Author: | Rug_Trucker [ Fri Jun 19, 2009 7:22 pm ] |
| Post subject: | |
I have seen a minimum of 4-5 different style of idle screws in my BBD collection. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|