| Slant Six Forum https://slantsix.org/forum/ |
|
| pistons & rods https://slantsix.org/forum/viewtopic.php?t=3606 |
Page 1 of 1 |
| Author: | Kenny B [ Sun May 12, 2002 10:09 pm ] |
| Post subject: | pistons & rods |
What pistons are able to be used in the /6? I was just looking at ebay and seen some rods with attached forged Mahle VW pistons, are these a good choice? Are there any aftermarket rods available? Is there a catalog available showing aftermarket parts for the /6? budbandy@swbell.net |
|
| Author: | Doc. [ Mon May 13, 2002 1:15 pm ] |
| Post subject: | Re: Metric pistons & aftermarket rods |
Quote:
: What pistons are able to be used in the /6? I : was just looking at ebay and seen some rods : with attached forged Mahle VW pistons, are : these a good choice? Are there any : aftermarket rods available? : Is there a catalog available showing : aftermarket parts for the /6? No catalog of Sl6 parts that I know of, there is a wide range of metric pistons which can be used, watch for the .901 piston pin size (2.2 Mopar) or else you will have to ream or bush the small end to fit the piston pin. $129 for a set of bushed 198 rods is a pretty good price. <A HREF="http://www.slantsix.org/cgi-bin/webbbs_config.pl?read=8214">http://www.slantsix.org/cgi-bin/webbbs_config.pl?read=8214</A> DD |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|