| Slant Six Forum https://slantsix.org/forum/ |
|
| Cam out of '64 https://slantsix.org/forum/viewtopic.php?t=36559 |
Page 1 of 1 |
| Author: | ceej [ Sat Aug 01, 2009 11:43 am ] |
| Post subject: | Cam out of '64 |
I pulled the engine down the other day and dropped it off for a good scrubbing and inspection at the machine shop. I was looking at the camshaft sitting next to my tank. The only legible number on it is 900954. Anybody know what this is? The # is stamped into the rear end of the camshaft. CJ |
|
| Author: | ceej [ Sat Aug 01, 2009 11:54 am ] |
| Post subject: | |
Just Measured lift. Looks like this thing will run somewhere around .4125" Gross valve lift. I/E are the same measurement. Looks like a stocker to me. Time to call Oregon Cam grinding. It's in great shape, so might as well use it as a core!  Josh? Where'd you put those cam profiles? Didn't you post a table? CJ |
|
| Author: | Joshie225 [ Sat Aug 01, 2009 7:06 pm ] |
| Post subject: | |
http://www.slantsix.org/forum/viewtopic.php?p=191616 |
|
| Author: | ceej [ Sat Aug 01, 2009 10:08 pm ] |
| Post subject: | |
Thanks Josh! CJ |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|