Update: If anyone else wants mounts, please fill out the form ASAP, deposits are now being put down. Read on for more information[/b]
DEPOSIT INFORMATION
Please make sure you indicate on the deposit (paypal or mail) that you are ordering 62-66 Slant Six engine mounts.
Paypal: glhs289@hotmail.com
Check by Mail:
Johnny Spiva
PO Box 4283
Coos Bay Oregon 97420
---------------------------------------------------------------------
To participate, please take a moment to fill out the order form
Everyone who has expressed interest needs to fill this form out!
-------------
List of Buyers (as of 9/21/09
Number of Sets ordering @ $99/set First Name Last Name
2 CJ Stoakes
1 Daniel Stern
2 Dick Sappington
1 Ray Taylor
1 Frank Brent
1 Gary Sand
1 Dana Chapman
1 Anthony Todaro
2 Steve Whitmarsh
1 Charles Hudacko
1 Doc Dodge (Dutra)
2 David Kight
1 Michael Hughes
1 Rod Bond
1 Menko Johnson
1 Louis Madsen
1 Seymour Pederson
1 Daniel Miller
1 Mike Andreas
1 Chuck Ellis
2 Richard Bjerklund
1 Greg Mader
2 Walter Lee Jackson
1 Matt Cramer
2 silas branton
2 Michael Robinson
1 firoz mohammed
1 Matthew Cramer
1 James Christianson
If your name is not on this list, please fill out the order form[/b][/u] and be sure you get to the confirmation page. Deposits will be rounded up in mid-September.
------------------
Hi everyone,
As you know, several people on this list, namely SlantSixDan, have tried for years to get vendors like Imperial interested in making poly engine mounts for the early A body slant six cars. It has never materialized, however, the spool mounts for '73+ cars created by Johnny at Polybushings.com have been well received which spurred us to contact Johnny and see what it would take to have him make some for the early 62-66 cars.
The cars these mounts would be designed for are:
US & Canadian Cars:
'62 Dodge Lancer
'62-'66 Plymouth Valiant
'63-'66 Dodge Dart
'64-'66 Plymouth Barracuda
Australian cars:
S, AP5, AP6, and VC Valiants
Now for the group buy information. Johnny has committed to building these mounts IF we get a minimum of 15 sets ordered. At that small size run, the price will be around $100 per set. If we had 25 sets, the price would decrease by about 10%
Since these mounts are not currently in production, each person will be asked for a $20 deposit as a good faith measure to demonstrate that there is a large enough group of committed buyers for these mounts.
I know the price is higher than many people are used to paying for mounts, but these poly mounts would likely never need to be replaced and would be far better than the rubber ones currently available and much easier on your dental work than those solid ones some of you are running out there =)
We are also exploring seeing if other vendors would like to carry these, so if you can think of someone who would perhaps like to resell these, a higher volume order could take the price down.
So..if you're interested in these, please reply below and I will start putting together a list. Again these are poly mounts for the 62-66 cars. If you have a 60-61 car, just swap that K member out and you're golden.
Thanks guys, let me know if you have any questions!
MJ[/b]
