hello,
these headers are Perry,very similar to Pacemakers,and as you will see,they go right where your LHD steering box is. So the answer is NO,they are not suitable. Please disregard the rust spots,they do need a touch-up.
regards,Rod
[/i]
| Slant Six Forum https://slantsix.org/forum/ |
|
| Australian headers work in LHD car? https://slantsix.org/forum/viewtopic.php?t=37902 |
Page 1 of 1 |
| Author: | robertob [ Tue Nov 10, 2009 5:17 pm ] |
| Post subject: | Australian headers work in LHD car? |
Wondering if Pacemaker headers would work on a US-market early A-body. Anyone tried? |
|
| Author: | SlantSixDan [ Tue Nov 10, 2009 5:20 pm ] |
| Post subject: | |
Very likely not. Remember, there's no steering box in the way on the Australian cars, but the oil filter is over there. The K-frame and steering linkage are different, too. So all the tubes bend very differently. |
|
| Author: | walpolla [ Tue Nov 10, 2009 10:42 pm ] |
| Post subject: | |
hello, these headers are Perry,very similar to Pacemakers,and as you will see,they go right where your LHD steering box is. So the answer is NO,they are not suitable. Please disregard the rust spots,they do need a touch-up. regards,Rod [/i]
|
|
| Author: | Charrlie_S [ Wed Nov 11, 2009 4:13 am ] |
| Post subject: | |
From what I understand, there are some Austrailian headers being built and prototypes being shipped over here very shortly for test fitting on our left hand drive cars. |
|
| Author: | 66aCUDA [ Wed Nov 11, 2009 5:24 am ] |
| Post subject: | |
Yep Keep your eyes open for a test drive and report. Frank |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|