I was able to get a MP 276 cam out of ebay. You should check there since every now and then something good appears.
Now that I'm thinkig 80% of my new engine came from Ebay!
| Slant Six Forum https://slantsix.org/forum/ |
|
| Is the Erson cam buy still available? https://slantsix.org/forum/viewtopic.php?t=37913 |
Page 1 of 1 |
| Author: | Imperial cruiser [ Wed Nov 11, 2009 7:40 am ] |
| Post subject: | Is the Erson cam buy still available? |
Looks like it's been a while, is the the deal still on? If not, where are you folks getting cams? Thanks |
|
| Author: | 60 Pioneer [ Wed Nov 11, 2009 8:28 am ] |
| Post subject: | |
When I talked with Erson about a month ago, they still didn't have any blanks and didn't know when they would be getting any. I ended up getting a regrind from Oregon Cams. |
|
| Author: | Imperial cruiser [ Fri Nov 13, 2009 6:36 am ] |
| Post subject: | |
What about the Direct Connection/MP cams? Are they available? Anyone? Bueller.....Bueller..... |
|
| Author: | Reed [ Fri Nov 13, 2009 8:09 am ] |
| Post subject: | |
Direct Connection stopped selling slant six parts years ago. There are probably a few NOS cams kicking around NOS parts resellers, possibly even in a Mopar dealership or two. You could try getting the part number for the specific cam you want and having the parts counter guy run an inventory search of all the dealerships, but I don't think there are any left. I know that back in about 98 or 99 I bought the second to last MP double roller timing set for a slant six, and at that time there was only one or two MP 244 cams still on dealership shelves (I had the parts guy do a search). By this time I figure they are all gone. |
|
| Author: | Polara1974 [ Fri Nov 13, 2009 2:16 pm ] |
| Post subject: | |
I was able to get a MP 276 cam out of ebay. You should check there since every now and then something good appears. Now that I'm thinkig 80% of my new engine came from Ebay!
|
|
| Author: | Imperial cruiser [ Sun Nov 15, 2009 8:19 am ] |
| Post subject: | |
It figures, I finally get around to working with a slant and all the parts dried up. My search continues, thanks guys. |
|
| Author: | Joshie225 [ Sun Nov 15, 2009 11:14 am ] |
| Post subject: | |
Quote: It figures, I finally get around to working with a slant and all the parts dried up. My search continues, thanks guys.
What parts do you want that you cannot find?
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|