| Slant Six Forum https://slantsix.org/forum/ |
|
| Make your own custom length pushrods https://slantsix.org/forum/viewtopic.php?t=39039 |
Page 1 of 1 |
| Author: | heckshemi [ Thu Feb 18, 2010 3:38 pm ] |
| Post subject: | Make your own custom length pushrods |
I bought from Summit some Comp Cams slant six pushrods for $32.99, stock length. These have pressed in cups so they're easy to shorten to any desired length. I just put in vise between two blocks of wood and twisted off cup end with vise-grips then cut tube to desired length and pressed end back on. A lot cheaper than having custom pushrods made. |
|
| Author: | Joshie225 [ Thu Feb 18, 2010 7:42 pm ] |
| Post subject: | |
I come up with Comp Cams part number 7864-12. Is that what you got? |
|
| Author: | madmax/6 [ Thu Feb 18, 2010 10:28 pm ] |
| Post subject: | |
What dia and material? I am very interested in this if I get my rockers in the next week.Guzzi Mark |
|
| Author: | heckshemi [ Fri Feb 19, 2010 7:52 am ] |
| Post subject: | |
Yes, 7864-12 is the part number. They don't list them for a slant six but they are 9.830" length, 5/16" dia. Not sure of the material. |
|
| Author: | Brian [ Fri Aug 06, 2010 6:48 am ] |
| Post subject: | |
Has anyone else used these pushrods? |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|