| Slant Six Forum https://slantsix.org/forum/ |
|
| MLS head gaskets https://slantsix.org/forum/viewtopic.php?t=39878 |
Page 1 of 1 |
| Author: | Slant 6 Duster [ Sat Apr 17, 2010 9:53 pm ] |
| Post subject: | MLS head gaskets |
I've searched around on the website and found that people have inquired about Cometic MLS head gaskets. Are they available? I'm currently using the Aussie permaseal head gasket in my boosted slant and having good luck so far. I also found MLS gaskets here, graphite though. http://www.gprsmopars.com/shopping/pgm- ... D#MOREINFO My question is are there any other gasket options besides o-ringing the block and going to copper. The Cometic MLS head gasket would be nice if their available. |
|
| Author: | Dart270 [ Sun Apr 18, 2010 5:20 pm ] |
| Post subject: | |
They are not available, but if we rally the troops we may get them to make one. I think we'd have to presell 30-50 gaskets to make it happen. I am also very interested in a Cometic MLS for boost, and to fit the aluminum engine. Lou |
|
| Author: | Walter Lee Jackson [ Sun Apr 18, 2010 11:15 pm ] |
| Post subject: | MLS head gaskets |
Could these gaskets be used on an aluminum block slant six? If yes, I'll take four. --Walt Jackson |
|
| Author: | 66aCUDA [ Mon Apr 19, 2010 7:38 am ] |
| Post subject: | Re: MLS head gaskets |
Quote:
These ARE the Permaseal Gaskets. This is the gasket I sell.Frank |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|