Quote:
Couldn't you peen the inside to hold the cap properly?
How would I go about doing that???
| Slant Six Forum https://slantsix.org/forum/ |
|
| Front U-joint is loose https://slantsix.org/forum/viewtopic.php?t=39893 |
Page 1 of 1 |
| Author: | CARS [ Mon Apr 19, 2010 10:19 am ] |
| Post subject: | Front U-joint is loose |
I changed the u-joints on my '68 Dart yesterday and I noticed that the cups that go in the yoke where not very tight. I just tapped them out after pulling the retaining clips. When I installed the new joint, I had to press in the half that goes on the drive shaft, but the yoke half was loose. I was able to push them into place with my hands. I guess I better go shopping for a new yoke. Any shopping tips for this part? |
|
| Author: | Dart270 [ Mon Apr 19, 2010 11:16 am ] |
| Post subject: | |
I think Mancini has them? I may have a spare... Lou |
|
| Author: | Shaker223 [ Mon Apr 19, 2010 11:18 am ] |
| Post subject: | |
Couldn't you peen the inside to hold the cap properly? |
|
| Author: | CARS [ Mon Apr 19, 2010 11:37 am ] |
| Post subject: | |
Quote: Couldn't you peen the inside to hold the cap properly?
How would I go about doing that???
|
|
| Author: | Shaker223 [ Mon Apr 19, 2010 12:55 pm ] |
| Post subject: | |
Hammer and punch. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|