| Slant Six Forum https://slantsix.org/forum/ |
|
| Early wheel bearings https://slantsix.org/forum/viewtopic.php?t=40045 |
Page 1 of 1 |
| Author: | madmax/6 [ Fri Apr 30, 2010 6:48 pm ] |
| Post subject: | Early wheel bearings |
Had a wheel bearing go out a couple years ago on my 62 valiant,had a hard time finding the correct early small ones.Finall found them and bought two.Only replaced the bad one and stashed the other one.Sold the rear end to a friend and the other side is bad and I cant find where I stashed the other new one,and cant remember where I finally found them.Can anyone help?Dumb Mark |
|
| Author: | sandy in BC [ Fri Apr 30, 2010 7:42 pm ] |
| Post subject: | |
Its under the grinder bench in a Sears shoe box....wrapped in tissue paper. |
|
| Author: | madmax/6 [ Fri Apr 30, 2010 8:45 pm ] |
| Post subject: | |
Nope,thats the third place I looked.Mark |
|
| Author: | Charrlie_S [ Sat May 01, 2010 5:09 am ] |
| Post subject: | |
Mark, do you have the OEM part number? |
|
| Author: | SlantSixDan [ Sat May 01, 2010 11:39 am ] |
| Post subject: | |
Last set of these I bought was from Svigel Auto Parts in Denver: Svigel's Auto Parts Inc. 4393 South Santa Fe Englewood, CO. 80110 303-781-7859 |
|
| Author: | maxracer21 [ Sat May 01, 2010 12:48 pm ] |
| Post subject: | cam bearings |
It's always the last place you look |
|
| Author: | madmax/6 [ Sat May 01, 2010 5:41 pm ] |
| Post subject: | |
Got one,Old6rodder just showed up at my shop and gave me one,THANK YOU VERY MUCH.This forum is fantastic,thanks Dan for the info.Mark |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|