| Slant Six Forum https://slantsix.org/forum/ |
|
| Mopar electronic ignition https://slantsix.org/forum/viewtopic.php?t=40205 |
Page 1 of 1 |
| Author: | Fastjeff [ Wed May 12, 2010 6:44 am ] |
| Post subject: | Mopar electronic ignition |
Question: Mid-80s Mopar electronic ignition uses a ballast resistor. Has anyone replaced the resistor AND the coil with a true, 12 volt coil? If so, has this worked out okay (no coil or ECM burnout issues)? Thanks! Jeff |
|
| Author: | Aggressive Ted [ Wed May 26, 2010 8:52 am ] |
| Post subject: | |
Not quit sure what your asking..... However, I have tossed the resistor so the system gets a full 12-15 volts all the time and replaced the coil with a Pertronix 12 volt 3 ohm coil. The system works great! I am running a older MOPAR orange ECU. |
|
| Author: | Fastjeff [ Wed May 26, 2010 12:55 pm ] |
| Post subject: | |
That's exactly what I needed to know! Thanks! Jeff |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|