Slant Six Forum
https://slantsix.org/forum/

Wiseco Ring Question
https://slantsix.org/forum/viewtopic.php?t=40299		 Page 1 of 1
Author:  stonethk [ Tue May 18, 2010 4:27 pm ]
Post subject:  Wiseco Ring Question
Anybody know what the final finish grit stones on the bores should be for the Wiseco rings?
There was no literature specifying this- 85 (600 grit) or 65 (400 grit)? on an SK10 machine.

My machinist wants to know what stone Wiseco recommends,
he said normally 65 for street and 85 for strip, I just wanted to verify if any one knows this info as it is too late to call.

Of course that means I want a 75 right LOL :twisted:

P.S.
Joshua if you read this- Hone plate will be shipped to your machine shop 9:00 am tomorrow, the guy wants to let the block cool down with it on.
Author:  wvenable [ Tue May 18, 2010 6:42 pm ]
Post subject: 
Don't quote me but IIRC 1st run is 280 grit followed by 400 grit. I think plateau brush was mentioned. This is what Wiseco folks told me after I bought Guzzi Mark's .45 over slugs. Someone chime in and confirm.
Author:  CNC-Dude [ Tue May 18, 2010 8:00 pm ]
Post subject: 
Depends more on what type of ring material you are using, not the brand. Stainless, moly, chrome, cast, etc....
Author:  stonethk [ Tue May 18, 2010 10:38 pm ]
Post subject: 
Thyanks guys, I'll call Wiseco tomorrow and see what they recommend.
Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/