| Slant Six Forum https://slantsix.org/forum/ |
|
| '63 PB904 trans info needed https://slantsix.org/forum/viewtopic.php?t=40335 |
Page 1 of 1 |
| Author: | hellion_locdogg [ Fri May 21, 2010 3:47 pm ] |
| Post subject: | '63 PB904 trans info needed |
I'm in the middle of my teardown starting last night. I need to know the band adjustments, I know they are different from early to late models. I do have a book that calls for 72 in lbs then out 2.5 low and 4 high. Also for kickdown adjustment on valve body it calls for a gauge tool, anybody know the dimension for that? I can use gauge blocks if needed. Trans looks good except for the high band drum, ouch. I brought it to work to turn it on the lathe. It looks to be a groud surface but I'm sure I can get a good finish on the lathe. Some of the friction plates were actually deteriorating, not worn just falling apart. I suspect that is what happened to the high band, it sure chewed the drum. Should have it back together in a snap. Was not as nearly as intimidating once I got into it. Thank God for an arbor press and manuals. ,Cliff |
|
| Author: | hellion_locdogg [ Tue May 25, 2010 6:51 pm ] |
| Post subject: | |
Anyone? Are they the same? Remember seeing that they were different. ,Cliff |
|
| Author: | SlantSixDan [ Tue May 25, 2010 7:17 pm ] |
| Post subject: | |
See here |
|
| Author: | Fopar [ Tue May 25, 2010 7:45 pm ] |
| Post subject: | |
Adjust with 1/8" drill between arm and plunger |
|
| Author: | hellion_locdogg [ Tue May 25, 2010 8:05 pm ] |
| Post subject: | |
Got the kickdown adjustment, thanks though. Need to know band adjustment. ,Cliff |
|
| Author: | Fopar [ Tue May 25, 2010 9:09 pm ] |
| Post subject: | |
2 1/2 front and 4 on rear |
|
| Author: | hellion_locdogg [ Tue May 25, 2010 9:20 pm ] |
| Post subject: | |
Ok, so it is the same as a later model? I thought that I had see that it was different between the two!? I obviously don't remember the difference though. LOL Thanks Fopar... ,Cliff |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|